Build a complete dining set: a 60-inch plank table and four matching slat-back chairs. It's all made from 2x4 and 1x4 lumber with screws, with no special joinery.
Download the free PDF preview below to see the overall size, the dimensioned views and the tools you need. When you are ready to build, the full plan gives you the complete cut list, shopping list and every assembly step.
Project at a glance
- Overall size: Table 60" W x 28" D x 31.5" H
- Skill level: Beginner
- Build time: 4–6 hours
- Main materials: Western Red Cedar Lumber 1"×4", Western Red Cedar Lumber 2"×4"
- Tools: Miter Saw, Jigsaw, Drill & Driver, Countersink Drill Bit, Clamps, Orbital Sander, Tape Measure, Speed Square, Paintbrushes
What's in the free preview
- Cover sheet with overall size, skill level and build time
- Dimensioned front, side, top and 3D views
- Estimated build time and recommended tools
- Nominal vs. actual lumber size chart
What you get in the full plan
- Complete material shopping list with quantities
- Complete cutting list with every board length
- 7 illustrated step-by-step assembly instructions
- Screw locations, pre-drilling and fastening details
- Finishing, safety and care notes
- 18-page printable PDF (8.5" x 11")
Get the full Haven Dining Table & 4 Chairs plan for $9.99 →
How the build comes together
Here is the order of work in the full plan:
- Assemble side frames for table
- Add the upper supports for table
- Install the tabletop boards for table
- Assemble the two side frames
- Attach the rear posts
- Install the four seat boards
- Install the three backrest boards
Tips before you start
- Pick straight, dry boards for the top so it stays flat.
- Sand the top through 120, 180 and 240 grit before finishing.
- Use a durable clear coat (polyurethane or hardwax oil) on surfaces you use every day.
FAQ
Is this plan free?
The preview PDF is free. It shows the size, dimensioned views and tool list. The complete plan with the cut list and step-by-step instructions is $9.99.
Can a beginner build it?
Yes. The plan is rated beginner and uses simple screwed joints and common tools.
Are the measurements in inches?
Yes, all plans use imperial units (feet and inches) and US lumber sizes.
How do I get the full plan?
Buy it on the Haven Dining Table & 4 Chairs plan page and we email you the complete PDF.
